Z Axis Probing Issues - General Discussion - Klipper
Por um escritor misterioso
Descrição
Basic Information: Printer Model: Custom CoreXY MCU / Printerboard: rPi 4B, Octopus V1.1 & FLY SHT42 klippy.log (851.2 KB) I have two issues that need to be addressed when trying to implement sensorless homing that will allow SAVE_CONFIG updates from functions like SHAPER_CONFIGURATION. This is a continuation to Problem with SHAPER_CALIBRATE & TMC2209s with Sensorless Homing 1. Updating printer.toolhead.homed_axes after single axis homing: I’m using the following code to implement TMC2
Error: bad Command XXX W/RRF 3.2 and leveling issue
Klippers -- A Place for Fellow Users of the Klipper Firmware
Feature Request : Z leadscrew mapping - Features - Klipper
Anybody using a Duet board with a Klipper SBC?
Z Errors - Probe Test and Offset wrong : r/klippers
BLTouch is not stopping the Z axis when the probe pin is pressed in. : r/klippers
Z axis moves down by z_hop_value - General Discussion - Klipper
Amount of Z-axis movement is unstable - General Discussion - Klipper
5 z axis motors, but only used 1 z axis motors to run for printing - Features - Klipper
de
por adulto (o preço varia de acordo com o tamanho do grupo)
